Road sign Crosses

Our road sign crosses are a series consisting of four different sized crosses, as well as an extension kit for the slightly larger signs.
When storing, the cross is folded completely, so it takes up less space and is easier to transport.

The junctions are made of UV-protected and impact-resistant plastic (even at cold temperatures).

When a road sign is to be "crossed", you loosen the steering wheel, adjust the angle of the cross and then fasten it with the steering wheel again.
The cross is then attached over the road sign and the "tear pairs" on the back hold the cross in place.
Cross-marking a brand couldn't be easier!!

If you wish to increase the size of the cross, there is an extension kit that extends the two bottom parts of the cross by 800mm.

The crosses can then be 600-2000mm long according to different needs.

The red reflective foil (RA/2) sits well protected between the raised edges, which ensures a long service life.
The cross can also be mounted on signs with a thicker sign frame.

To facilitate the installation of the cross, there is also a mounting bracket, on occasions when the mark is high up.

At all diversions, road markings that are currently out of date must be "crossed" or covered.

This has been a very costly and complicated story both regarding the installation of the only alternative that previously existed (red reflective tape).

Now there is a solution which is:
#Reusable and thus better for both the environment and wallet.
#Faster & easier to install.
#Takes minimal storage space.
#Do NOT adventure the reflective foil on the mark behind the cross, (which otherwise easily comes along, or in any case parts of it when the tape is removed and traffic should return to normal.)
#Customizable to fit any brand.


Take a look at our brochure or click on the pictures for a description.